Looking after your weapons

[Dirty Heathen]

Ok so I just got my desert eagle today what is needed to be done to keep a weapon clean and in good working order or general maintenance?

[wege]

just keep it clean.
Spray some 100% silicone spray into the gas flow unit every now and then.. not all the time.
and occasional spray into the hammer/bits/area inside.
maybe a hint along the rails.

in short. .not much.


Don't drop it. :)

[Dirty Heathen]

So silicone spray is best to keep them lubricated.

[BLACKHAWK]

yep dont use anything thats petroleum based otherwise they eat your seals. Try not to get the barrel or hopup siliconed otherwise it will be unaccurate as shit.

[Spec_Al]

I also find if you have a cleaning rod for it get a little patch of cloth and swab the barrel dont use any silicone, as every bit of fluff and crap around will put up residence in there

its helps to stop the barrel from getting scratched which murders accuracy

If you dont have a cleaning rod a thin bit of sring with the cloth tied to one end works just and well

[BLACKHAWK]

+1 on what that man said

[Painless]

meh just throw it in your draw with everything else.

[BLACKHAWK]

lol lol

[Dirty Heathen]

I got a propane nozzle as well I went and got a bottle of propane from the camping shop I don't know if I am using it properly it still fill the clip up but there is still a lot of gas coming out of the nozzle or bottle stinks like shit lol.

I could not find any bottle that had a oring the same size as the piece thats goes in maybe thats the problem.

[Yoichi]

what sort of gas did you get?

[Dirty Heathen]

What sort was I meant to get lol?

[McArthur]

Propane I think. Propane+Silicone oil = Green Gas

[Dirty Heathen]

I just straight propane I have put so silicone around the nozzle.

[Dirka]

Colemans.
One or two other brands out that have the right size top for your adaptor.

[Dirty Heathen]

I got Coleman.